![](/images/new-backgrounds/1210469/21046921x1.webp)
ASSEMBLY
1.Lubricate the smaller
2.Install this
3.At the other end of the check valve body, the spring is installed over the set of four straight guide lands. When the spring has been pushed to the correct location, the check valve body is designed to hold the end of the spring in position: be sure that the spring is not loose before continuing with this installation.
4.Install the assembled check valve
5.Grease the adapter and the remaining larger
6.Position the governor gasket, then insert the governor mounting bolts through the governor and tighten (to 125
7.
8.Before placing vehicle back into service, check to see that the system pressure now builds to full operational pressure.
Log-on and Learn from the Best
Visit
11