Using the teaching templates | BenQ MX505, MS504 specs

Using the teaching templates

The projector provides several preset patterns for various teaching purposes. To activate the pattern:

1.Open the OSD menu and go to the DISPLAY > Teaching Template and press

/ to select Blackboard or Whiteboard.

2.Press / to choose the pattern you need.

3.Press MODE/ENTER to activate the pattern.

	Teaching	Whiteboard	Blackboard
	Template

Letter

Formation

Worksheet

Coordinate

Chart

Operation 33

Image 33

BenQ MX505, MS504 user manual Using the teaching templates, To select Blackboard or Whiteboard

Contents

MS504/MX505 Digital Projector Table of contents Safety Instructions Important safety instructions Safety Instructions 3000 m Feet Ceiling mounting the projector Introduction Projector features Shipping contents Front/upper side Rear/lower side Projector exterior view Controls and functions Remote control Replacing the remote control batteries Remote control effective range Choosing a location Positioning your projectorFront Table Front Ceiling Obtaining a preferred projected image size Projection dimensions Connection Connection Connecting audio Connecting video source devicesTerminal name Terminal appearance Component Video Better Good Normal Starting up the projector Operation Adjusting the projection angle Adjusting the projected imageAuto-adjusting the image Fine-tuning the image size and clarity Correcting keystone Below is the overview of the OSD menu Using the menus Utilizing the password function Using a security cable lockSetting a password If you forget the password Entering the password recall procedure Changing the passwordDisabling the password function Switching input signal Selecting the aspect ratio Magnifying and searching for details About the aspect ratio Selecting a picture mode Using Wall ColorSetting the User 1/User 2 mode Go to the Picture Picture Mode menu Fine-tuning the image quality in user modes Adjusting Brilliant ColorSelecting a Color Temperature 3D Color Management Setting a preferred color temperature Setting the presentation timer Resetting current or all picture modesSelection Description Remote paging operations To cancel the timer, perform the following stepsFreezing the image Top-Left Bottom-Left Top-Right Bottom-Right Hiding the image To activate the High Altitude ModeLocking control keys Operating in a high altitude environment Using the test pattern Adjusting the soundAdjusting the sound level Turning off the Power On/Off Ring Tone To select Blackboard or Whiteboard Using the teaching templates Shutting down the projector Direct power off Menu operation Teaching Coordinate Chart Template WhiteboardMenu system Main menu Sub-menu Options Ceiling/Front Ceiling BasicMenu Display Sec/10 sec/20 sec/30 sec Time Always Advanced Description of each menu Save 3D Settings Apply 3D SettingsTeaching Template Description 3D Sync Invert Temperature Function Description Picture ModeColor Temperature Fine Tuning 3D Color Timer System Setup Basic menu Function Description PresentationInstallation Settings Background LockColor Splash Screen Reset All System Setup Advanced menu Function DescriptionClosed Caption Current SystemStatus Care of the projector Maintenance Lamp information Getting to know the lamp hourExtending lamp life Status Message Timing of replacing the lamp Replacing the lamp Resetting the lamp timer Light Status & Description Power events IndicatorsLamp events Thermal events Troubleshooting Projector specifications Specifications Ceiling mount installation Dimensions Supported timing for PC input Timing chart Supported timing for Component-YPbPrinput Supported timing for Video and S-Video inputsTiming Limited warranty Warranty and Copyright informationCopyright Disclaimer