Blank | In order to draw the audience’s full attention to the presenter, you |
| can use Blank to hide the screen image. Press Blank again to |
| restore the image. Refer to page 21 for more information. |
|
|
Preset | According to the selected input signal, there are several picture |
| setup options available: Vivid mode, Presentation mode, Gaming |
| mode, Video mode, Cinema mode and Economic mode. Refer to |
| page 24 for more information. |
|
|
Remote Control Effective Range
Infra Red (IR) remote control sensors are located on the front and the back of the projector. The remote control must be held at an angle within 30 degrees of the projector’s IR remote control sensors to function correctly. The distance between the remote control and the sen- sors should not exceed 6 meters (19.5 feet).
Notes on Remote Control Operation:
Make sure that there are no obstacles between the remote control and the IR sensors on the projector that might obstruct the
Installing or Replacing the Battery
1.Pull out the battery holder.
2.Insert the new battery in the holder.
3.Push the holder into the remote control.
Avoid excessive heat and humidity. There may be danger of an explo- sion if the battery is incorrectly replaced. Replace only with the same or equivalent type recom- mended by the manufacturer. Dis- pose of the used battery according to the manufacturer’s instructions.
10 Introduction
