Video devices Video cable Audio cable | BenQ PB2240 specification

Video devices

Video cable

Audio cable

If the selected video image is not displayed after the projector is turned on and the correct video source has been selected, check that the video source is turned on and operating cor- rectly. Also check that the signal cables have been connected correctly.

Connection 13

Page 17

Image 17

BenQ PB2240 user manual Video devices Video cable Audio cable

Contents

Welcome Disclaimer Copyright Table of Contents Ordering Parts or Getting Information Iv Table of Contents Important Safety Instructions Important Safety InstructionsBut could fail if power cuts or surges Safety Instructions Locations with an ambient temperature Locations near fire alarmsUsing the unit when it is not fully Bedding or any other soft surface Safety Instructions Introduction Projector FeaturesIntroduction Shipping Contents Projector Exterior View Optional AccessoriesFront / Upper Side Rear Side Controls and Functions Adjusts the focus of the projected image IntroductionExternal Control Panel Turns the projector on or off Functions Descriptions Remote Control Description Restore the image. Refer to page 21 for more information Remote Control Effective RangeInstalling or Replacing the Battery Connection Connecting to a Laptop or Desktop Computer Connecting Video and S-Video Devices Connecting Equipment to the Component Video InputVideo devices Video cable Audio cable Connection Video devices Video cable Audio cable IV. Ceiling rear InstallationChoosing a Location Press the adjuster button again to retract the foot Adjusting the HeightZoom ring Installation Screen Size Screen size chart 169 aspect ratio Screen size chart 43 aspect ratio Operation OperationStart Up Shutdown Disconnect the power cord from the wall socket For example Digital Keystone Correction Source Selection Auto Adjustment Blank Zoom / Focusing Menu System Menu Operation Ing 3 Left / Right 4 on Using the MenusProjector or 3 / 4 on Use 3 Left / Right 4 on the projector Picture Menu Preset ModeKeystone Brightness Increases or decreases the color intensity of the image ColorTint Pro-Picture Menu Volume OSD Time Setting MenuReset Mute Advance Menu High Altitude Mode Information Menu ResolutionSource Lamp Hour Cleaning the Lens MaintenanceCleaning the Projector Case Storing the Projector Message Status Lamp InformationReplacing the Lamp For 45 minutes until the lamp has cooled Temp Information IndicatorsLight Status & Description Power Temp Lamp Power events Thermal events Lamp eventsNew one immediately Please contact your dealer for assistance Accessories included in the standard package Service InformationOptional Accessories not included in the standard package Ordering Parts or Getting Information Plug the power cord into the AC inlet on TroubleshootingMake sure that it is switched on Cause Remedy Projector Specifications Specifications Operating altitude Feet at 30C 6000 ~ 10000 feet at 23C DimensionsEnvironmental Requirements Supported Timing for PC Input Timing ChartSupported Timing for Component-YPbPrInput Supported Timing for Video and S-Video Inputs Warranty WarrantyLimited Warranty FCC Statement Regulation StatementsEEC Statement MIC Statement