Lamp Information
Warning Message
When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a mal- function in the projector and in some instances the lamp may break.
For more detailed information on lamp warnings, please refer to page 34.
The Lamp indicator light and Temperature warning light will light up if the lamp becomes too hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after turning the power back on, please contact your dealer.
The following Lamp warning displays will remind you to change the lamp.
Message | Status | ||||
|
|
|
|
|
|
|
|
|
|
| The lamp has been in operation for 1980 hours. |
|
|
|
|
| |
|
|
|
|
| Install a new lamp for optimal performance. If the |
|
|
|
|
| projector is normally run with Preset "Economic |
|
|
|
|
| Mode" selected (page 24), you may continue to |
|
|
|
|
| operate the projector until the 2980 hour lamp |
|
|
|
|
| warning appears. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| The lamp has been in operation for 2980 hours, the |
|
|
|
|
| |
|
|
|
|
| power will shutdown in 20 hours time. A new lamp |
|
|
|
|
| should be fitted to avoid the inconvenience when the |
|
|
|
|
| projector runs out of lamp time. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| The lamp has been in operation for over 3000 hours. |
|
|
|
|
| This message will flash in the center of the screen |
|
|
|
|
| together with the Lamp indicator lighting up red for |
|
|
|
|
| 40 seconds. The projector will shutdown after 40 |
|
|
|
|
| seconds. The lamp MUST be replaced before the |
|
|
|
|
| projector will operate normally. |
|
|
|
|
|
|
|
|
|
|
|
|
Replacing the Lamp
To reduce the risk of electrical shock, always turn the projector off and disconnect the power cord before changing the lamp.
To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes before replacing the lamp.
To reduce the risk of injuries to fingers and damage to internal components, use caution when removing lamp glass that has shattered into sharp pieces.
To reduce the risk of injuries to fingers and/or compromising image quality by touching the lens, do not touch the empty lamp compartment when the lamp is removed.
This lamp contains mercury. Consult your local hazardous waste regulations to dispose of this lamp in a proper manner.
32 Maintenance
