Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 2
To adjust the projector, slightly lift the front of the projector and press and hold the
To retract the foot, hold up the front of the projector while pressing the
If the projector is not placed on a flat surface or the screen and the projector are not perpendicular to each other, the projected picture becomes trapezoidal. To correct this situation, see "Correcting keystone" on page 28 for details.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press AUTO on the projector or remote control. Within 3 seconds, the
The current source information will be displayed in the corner of the screen for 3 seconds.
The screen will be blank while AUTO is functioning.
Fine-tuning the image size and clarity
1.Adjust the projected image to the size that you need using the zoom ring.
2.Then sharpen the image by rotating the focus ring.
iii
i.Be aware of the vent where hot air comes from.
ii.Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyes.
Operation 27