W10000-en.book Page 31 Thursday, October 19, 2006 1:45 PM

To clean the filter:

1.Shut down the projector if turned on and wait until the fans stop running.

2.Release the bottom edge of the filter cover (right side of projector) by gently pulling the tabs on the lower ends of the panel (as illustrated).

English

3. Remove the filter cover by gently lifting the

4. Remove the dust filter grill by pulling the tab

loosened cover vertically upwards and then away

outwards and away from the projector.

from the projector body.

 

5. Use a small vacuum cleaner (designed for

6. Re-install the filter grill and cover securely.

computers and other office equipment) or use a

 

soft brush (such as a clean artist’s paintbrush) to

 

vacuum or sweep the dust away.

 

If the dirt is difficult to remove or the filter is

 

 

broken, you should replace it.

 

7. Reapply power and turn the projector on.

8. Go to Setup > Reset Dust Filter Timer to reset the

If the filter grill is not correctly seated in place,

filter timer. See page 28 for details.

you will be reminded by a message displayed on the screen every three minutes until MENU/EXIT on the projector or EXIT on the remote control is pressed.

Please check if the filter is well attached.

The projector will automatically shut down within minutes if there has been no further action taken. Re-install the filter and cover securely, then turn on the power again.

Additional information

31

Page 31
Image 31
BenQ W10000/W9000 To clean the filter, Remove the filter cover by gently lifting, Outwards and away from the projector