Berkel PM60, PM80 important safety instructions T528%/6+227,1, R3$,53$57653$,5659

T528%/(6+227,1*

If your mixer should fail to function, there are a few things you can check before calling a service technician. If you do need service, visit our web site at www.berkel.com. Pull down the service tab and click on your state. A list of the Designated Berkel Service Locations will be shown.

Motor will not operate when the start button is pushed

•The mixer is overloaded, activating the thermal overload switch. Correct the situation causing the overload by reducing the load or reducing mixing speed. See the product capacity chart on page 14.

•Set a time on the timer or turn the timer off.

•The bowl guard is not in place. Rotate the bowl guard fully to the right.

•The bowl is not fully up and in place. Lift the bowl to its fully up position.

Motor operates, but planetary does not turn in any of the speeds

•Internal drive or transmission linkage is inoperative. Contact your nearest Designated Berkel Service Location.

Hard to shift speeds

•Make sure the shift lever is fully engaged.

Mixer slips out of gear under load

•Make sure the shift lever is adequately engaged.

Product not being properly mixed at the bottom of the bowl

•Inadequate water to product ratio (AR)

•Excessive clearance at the bottom of the bowl and attachment. Contact your nearest Designated Berkel Service Location.

R(3$,53$5765(3$,56(59,&(

Please contact your nearest Designated Berkel Service Location for any repair parts and/or repair service required on your Berkel slicer. A list of DBSL’s can be found on the website at www.berkel.com. Pull down the service tab and then click on your start for the nearest DBSL. Additional information may be obtained from:

Technical Service Support Center

Berkel Company

4406 Technology Drive

South Bend, IN 46628-9700

(574)232-8222

(800)348-0251

12 • PM60 & PM80 OWNER/OPERATOR MANUAL