![](/images/new-backgrounds/1057005/5700529x1.webp)
Cut out
SERGING A TUBULAR PROJECT
| FABRIC: | Firm fabric 3” X 12” |
| NEEDLES: | 80/12 Universal |
| THREAD: | 4 cones of serger thread |
Instruction Manual pg.___ | PRESSER FOOT: | Standard |
Bernette Advanced Guide | Workbook pg.___ |
|
•Turn the Stitch Selection Dial to “A” on the Stitch Selection Panel.
•Thread the serger for a
•With right sides together, seam the fabric into a tube along the 3” side.
•Press the seam to one side. (The Upper Looper thread is the right side of the seam.)
•On one 12” side of the tube, cut away a 2” X ¼” section of fabric.
•Locate and remove the
•Raise the Presser Foot.
•Position the tube of fabric around the
•Lower the Presser Foot and serge around the tube, cutting off ¼”. Stop serging when the Knife enters the cutout.
•Rotate the Knife up.
•Continue serging to complete the circle, overlapping the previous stitching by 1”.
•Raise the Presser Foot and rotate the fabric clockwise.
•Lower the Presser Foot and serge off the edge of the fabric.
•Return the Knife to the normal Cutting Position.
•Return the
•Trim and mount the sample.
1999 BERNINA of America | page 15 |