SURFACE BURNER OPERATION
THERMOCOUPLE SAFETY VALVE
Each surface burner of a Bertazzoni range is equipped with a thermocouple safety device.
The thermocouple opens the flow of gas to the burner only when hot. Should the flame go off, the thermocouple will immediately close the gas flow to the burner eliminating any risk to your home.
For faster activation of the thermocouple, always light the burners on maximum power. This will allow the thermocouple to reach the optimum temperature in the fastest time.
ELECTRIC IGNITION
To activate the electric ignition, simply turn the control knob counter‐clockwise to maximum
power (
position). Press the knob to start the flow of gas and the ignition spark. The spark will released at the metal tip of the white ceramic pin located on the side of the burner. Once the flame is on, release the control knob gently.
If the flame turns off, repeat the above procedure.
The dual power‐burner is composed by two burners (inside and outside). Each burner is activated by a separate control knob. The two burners can be operated separately or together for maximum power. To activate the power‐ burner, turn on the central burner first, then turn on the external ring.
ATTENTION: do not ignite burners if the black burner cap is not installed or not centred. The flame will be irregular.
MANUAL IGNITION
Manual ignition is always possible even when the power is cut off or in the event of power failure.
Turn the control knob counter‐clockwise to the MAXIMUM position. Light the flame with a kitchen lighter or with a match.
TIPS FOR USING BURNERS CORRECTLY
WARNING!
KEEP CHILDREN AT A SAFE DISTANCE FROM THE
APPLIANCE DURING OPERATION.
DO NOT ALLOW CHILDREN TO OPERATE THE
APPLIANCE.
1.Always check that the burner caps are properly installed before operation.
2.Verify that the flame of the worktop burners is completely blue and with regular aspect as shown below.
3.Always adjust the burner flame so it does not extend beyond the edge of the pan.
26
