Beverage-Air 3311 manual Installing Your Unit cont, Model, Page

Installing Your Unit (cont.)

7. Review hopper contents to make sure all parts are available:

Part #	Description
W0600110	Manual
W0600073	Rubber Pad Sheet
W0600121	Merchandiser Installation Sheet
W0600012	MSDS Sanitizer Sheet
W0600159	Warranty Registration Card
W0890218	Drip Tray Kit
W0520094	Hopper Cover
W0480445	Valve Handle
W0631230	Valve Spring
*	Carb Tube
*	Dispense Valve Plunger
W0470076	Lubricant
W0631903	Sanitizer Packets
W0340022	O-rings

*Optional items specified when the unit is ordered.

8.Fill out Warranty Registration Card with the requested information and mail to Grindmaster Corporation.

9.Replace side panels.

10.Assemble the dispense valve following the instructions on page 9. The valve plunger, spring and retaining pin come in the small parts bag.

11.Be sure ON-OFF-CLEAN switch (toggle switch located underneath the electrical box) is in the “OFF” position.

12.Connect the power cord directly to a properly grounded DEDICATED 120V/60Hz, 15 Amp circuit or 220-240V/ 50Hz, 15 Amp circuit for CE models. Do not use an extension cord.

!Do not alter or deform the plug in any way! Altering or deforming the plug may damage unit and will void warranty.

13.Remove the drip tray kit from the bubble wrap. Separate the parts and remove the protective coating. The drip tray is mounted on two screws that are located on the lower front of the freezer cabinet.

14.Place the key hole slot of the drip tray support bracket (W0471022) on to these screws and tighten the screws.

15.Angle the back of the drip tray surround bracket into the drip tray support bracket (W0471022) and lower bracket to lock it into place.

16.Place drip tray onto drip tray surround bracket.

17.Place the louvered drip tray insert into drip tray.

Model 3311 Page 5