5IN THE INTEREST OF SAFETY

BEFORE STARTING ENGINE, READ AND UNDERSTAND THE “ENTIRE OPERATOR'S MANUAL &

ENGINE MANUAL.”

THIS SYMBOL MEANS WARNING OR CAUTION. DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY OCCUR UNLESS INSTRUCTIONS ARE FOLLOWED CAREFULLY.

The engine exhaust from this product contains chemicals known to the State WARNING! of California to cause cancer, birth defects or other reproductive harm.

WARNING: DO NOT

1.DO NOT run engine in an enclosed area. Exhaust gases contain carbon monoxide, an odorless and deadly poison.

2.DO NOT place hands or feet near moving or rotating parts.

3.DO NOT store, spill or use gasoline near an open flame, or devices such as a stove, furnace, or water heater which use a pilot light or devices which can create a spark.

4.DO NOT refuel indoors where area is not well ventilated. Outdoor refueling is recom- mended.

5.DO NOT fill fuel tank while engine is running. Allow engine to cool for 2 minutes before refueling. Store fuel in approved safety containers.

6.DO NOT remove fuel tank cap while engine is running.

7.DO NOT operate engine when smell of gasoline is present or other explosive conditions exist.

8.DO NOT operate engine if gasoline is spilled. Move machine away from the spill and avoid creating any ignition until the gasoline has evaporated.

9.DO NOT transport unit with fuel in tank.

10.DO NOT smoke when filling fuel tank.

11.DO NOT choke carburetor to stop engine. Whenever possible, gradually reduce engine speed before stopping.

12.DO NOT run engine at excessive

speeds. This may result in injury &

7

/or damage to unit.

 

13.DO NOT tamper with governor springs, governor links or other parts which may change the governed engine speed.

14.DO NOT tamper with the engine speed selected by the engine manufacturer.

15.DO NOT check for spark with spark plug or spark plug wire removed. Use an approved tester.

16.DO NOT crank engine with spark plug removed. If engine is flooded, place throttle in “FAST” position and crank until engine starts.

17.DO NOT strike flywheel with a hard object or metal tool as this may cause flywheel to shatter in operation. Use proper tools to service engine.

18.DO NOT operate engine without a muffler. Inspect periodically and replace, if necessary. If engine is equipped with muffler deflector, inspect periodically and replace, if necessary, with correct deflector.

19.DO NOT operate engine with an accumulation of grass, leaves, dirt or other combustible material in the muffler area.

20.DO NOT use this engine on any forest covered, brush covered, or grass covered unimproved land unless a spark arrester is installed on the muffler. The arrester must be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands.

SOUND

21.DO NOT touch hot muffler, cylinder, or fins because contact may cause burns.

22.DO NOT run engine without air cleaner or air cleaner cover.

23.DO NOT operate during excessive vibration!

24.DO NOT leave machine unattended while in operation.

25.DO NOT park machine on a steep grade or slope.

WARNING: DO

1.ALWAYS DO remove the wire from the spark plug when servicing the engine or equipment TO PREVENT ACCIDENTAL STARTING.

2.DO keep cylinder fins and governor parts free of grass and other debris which can affect engine speed.

3.DO pull starter cord slowly until resis- tance is felt. Then pull cord rapidly to avoid kickback and prevent hand or arm injury.

4.DO examine muffler periodically to be sure it is functioning effectively. A worn or leaking muffler should be repaired or replaced as necessary.

5.DO use fresh gasoline. Stale fuel can gum carburetor and cause leakage.

6.DO check fuel lines and fittings frequently for cracks or leaks. Replace if necessary

7.Follow engine manufacturer operating and maintenance instructions.

8.Inspect machine and work area before starting unit.

8VIBRATION

VIBRATION LEVEL 0.02g

6TABLE OF CONTENTS

SAFETY INSTRUCTIONS

2

GENERAL SAFETY

3

ASSEMBLY

3

PARTS BAG & CONTROLS

4

LABELS

4

OPERATION

5 - 7

MAINTENANCE

8 - 9

PARTS DRAWING & LIST

10 - 12

TROUBLESHOOTING

12

WARRANTY

12

Sound tests conducted were in accordance with 2000/14/EEC and were performed on 04/13/2004 under the conditions listed:

NOTE: Sound power level listed is the highest value for any model in this manual. Please refer to serial plate on the unit for the sound power level for your model.

Sound level of 94 dBA at operator position

 

GENERAL CONDITION:

Sunny

 

TEMPERATURE:

50.5° F (10.3° C)

120 dB

WIND SPEED:

0.5 MPH (0.8 kmh)

 

 

WIND DIRECTION:

North West

(HTR1803VEU

HUMIDITY:

39 %

MODEL)

 

BAROMETRIC PRESSURE:

30.18" Hg (767mm Hg)

 

Vibration levels at the operators handles were measured in the vertical, lateral, and longitudinal directions using calibrated vibration test equipment. Tests were performed on 07/14/94 under the conditions listed:

GENERAL CONDITION:

 

Sunny

TEMPERATURE:

 

78° F (23.8° C)

WIND SPEED:

 

16 MPH (25.7 kmh)

WIND DIRECTION:

South East

 

HUMIDITY:

 

62 %

 

BAROMETRIC

 

30.10" Hg (765mm Hg)

PRESSURE:

 

Part No. 811237

Page 2 of 12

Form No. F050304A

 

Page 2
Image 2
Billy Goat TR1304HEU, HTR1803VEU, TR1104EU specifications Sound, Vibration, Table of Contents

TR1304HEU, TR1104EU, HTR1803VEU specifications

The Billy Goat TR1304HEU, TR1104EU, and HTR1803VEU are high-performance outdoor power equipment designed for efficient debris and leaf management, offering unmatched reliability and ease of use for both residential and commercial users.

The TR1304HEU is a powerful specialized leaf blower, featuring a robust 130cc Honda engine. This model is known for its exceptional air volume and velocity, which can deliver air speeds of up to 200 mph. Its lightweight design allows for effortless maneuverability, reducing user fatigue during prolonged use. Additionally, the TR1304HEU includes an innovative hydrostatic drive system that allows for smooth speed control without the need for constant throttle adjustments. The self-propelling system provides precise speed control, making it suitable for tackling various terrains effortlessly.

Next, the TR1104EU model offers similar performance but is tailored for residential users seeking effective leaf and debris cleanup. Powered by a 110cc engine, this leaf blower provides a great balance of power and maneuverability. The TR1104EU is also equipped with large 10-inch rear wheels that enhance stability and facilitate easy movement across lawns and uneven surfaces. Its compact design makes it easy to store in smaller spaces, while the convenient foldable handle allows for comfortable transport and storage.

The HTR1803VEU is an advanced vacuum and chipper designed to handle larger volumes of leaves and debris effectively. Equipped with an 180cc engine, the HTR1803VEU excels in both vacuuming and chipping applications, making it an all-in-one solution for yard cleanup. It features a unique three-blade cutting system that can reduce yard waste down to a compact mulch, ideal for garden use. The innovative debris bag has a large capacity, reducing the need for frequent emptying, thereby enhancing productivity.

One of the standout features across all three models is their emphasis on operator comfort and ease of use. Each machine is designed with ergonomic handles and intuitive controls, allowing users to operate them with minimal effort. The durable construction ensures long-lasting performance, even in harsh weather conditions.

These models collectively embody Billy Goat’s commitment to quality and innovation in outdoor power equipment, providing users with dependable tools that make yard maintenance efficient and hassle-free. Whether for residential or professional use, the TR1304HEU, TR1104EU, and HTR1803VEU meet diverse needs and elevate the leaf management experience.