Form No F030106A 19 Part No 840186
WIRING DIAGRAMS
Bag Switch Circuit Schematic Diagram
Problem Possible Cause Solution
Will not vacuum or has poor vacuum
performance.
· Dirty or full debris bag or filter. · Clean debris bag and filter. Shake bag clean or
wash.
· Nozzle height set too high or too low. · Adjust nozzle height (see page 14).
· Hose kit cap missing. · Check for hose kit cap.
· Clogged nozzle or exhaust. · Unclog nozzle or exhaust (see page 16)
· Excessive quantity of debris. · Allow air to feed with debris.
Abnormal vibration. · Loose or out of balance impeller. · Check impeller and replace if required.
· Loose engine. · Check engine (see page 24 ).
Engine will not start. · Throttle in off position. · Check throttle control (see page 13).
· Engine not in full choke position. · Check throttle, choke position (see page 13).
· Out of gasoline or bad, old gasoline. · Check gasoline.
· Spark Plug wire disconnected. · Connect spark plug wire.
· Gas valve off. · Turn on gas valve.
· Dirty air cleaner. · Clean or replace air cleaner. Contact a qualified
service person.
· Safety Interlock disengaged on bag plate. · Latch the bag properly or check thr bag rod to see
if it's bent.
Engine is locked, will not pull over. · Impeller plugged or clogged. · Remove debris (see page 16).
· Engine problem. · Contact an engine servicing dealer for engine
problems.