Billy Goat MV650H 1st

Part No 840186 10 Form No F030106A

Your BILLY GOAT ® MV Vacuum was shipped in one carton, completely assembled except for the Hood/Upper

Handle Assembly. Mounting hardware for the Hood/Upper Handle Assembly is temporarily installed on the lower

handle and the Housing assembly.

READ all safety instructions before assembling unit.

TAKE CAUTION when removing the unit from the box the Hood/Upper Handle Assembly is

attached to the unit by cables.

Remove unit from carton. Make sure the following items that have been packed with unit:

Parts bag P/N 840190

 Owner’s Manual, P/N 840186

 Honda Engine Manual

 Warranty Card, P/N 400972

 Ty-Wraps (2 ea)

 Hardware Bag P/N 840190

DISCONNECT spark plug wire before assembling unit.

1. Attach hood assembly to the housing then hold in

place during the step 2.

NOTE: BE SURE ALL CABLES ARE ROUTED ON

THE UNDERSIDE OF THE HOOD AND HOUSING.

2. Install item #170 center bolt first when aligned with a nut

on the housing.

3. Attach rest of hood assembly to the housing using

corresponding hardware.

NOTE: You will have to insert the bolt/washer from the

inside by reaching through the hood.

- Two 7/16” wrenches.

1st