MV650SPH
OPERATOR CONTROLS
The operator’s position is at the rear of the machine between the handlebars. The operator should STAND in a position to allow both handlebars to be grasped firmly, which allows sufficient leverage to steer the machine. Operator’s controls are shown below.
3
4
6
1
5
2
| Operator Control Locations | ||
1 | Drive Clutch Lever | 4 | Throttle Control |
2 | Bag Latch | 5 | Drive Shifter Control |
3 | Pull Starter | 6 | Nozzle Door Adjuster |
STARTING
CHECK engine oil level before operating machine.
1.Place equipment on a level, firm surface that is free of rocks or other debris.
2.Place throttle in START position.
Throttle
DO NOT START equipment without the debris bag in place.
Form No F082206A | 13 | Part No 840099 |
