Billy Goat owner manual MV650SPH Self-Propelled Vacuum Owner’s Manual ASSEMBLY INSTRUCTIONS

MV650SPH Self-Propelled Vacuum Owner’s Manual

ASSEMBLY INSTRUCTIONS

Your BILLY GOAT ® MV Vacuum was shipped in one carton, completely assembled except for the Hood/Upper Handle Assembly. Mounting hardware for the Hood/Upper Handle Assembly is temporarily installed on the lower handle and the Housing assembly.

READ all safety instructions before assembling unit.

TAKE CAUTION when removing the unit from the box since Hood/Upper Handle Assembly is attached to the unit by cables.

Remove unit from carton. Make sure the following items that have been packed with unit: Parts bag P/N 840187

†Owner’s Manual, P/N 840099

†Declaration of Conformity, P/N 840204

†Honda Engine Manual

†Warranty Card, P/N 400972

†Ty-Wraps (2 ea)

†Hardware Bag

DISCONNECT spark plug wire before assembling unit.

1.Attach hood assembly to the housing then hold in place during the step 2.

NOTE: BE SURE ALL CABLES ARE ROUTED ON THE UNDERSIDE OF THE HOOD AND HOUSING.

2.Install item #170 center bolt first when aligned with a nut on the housing.

3.Attach rest of hood assembly to the housing using corresponding hardware.

NOTE: You will have to insert the bolt/washer from the inside by reaching through the hood.

1st

- Two 7/16” wrenches.

Part No 840099 10 Form No 082206A