MV650SPH Self-Propelled Vacuum Owner’s Manual

WIRING DIAGRAMS

Bag Switch Circuit Schematic Diagram

TROUBLESHOOTING

Problem

Possible Cause

Solution

Will not vacuum or has poor vacuum

· Dirty or full debris bag or filter.

· Clean debris bag and filter. Shake bag clean or

performance.

 

wash.

 

· Nozzle height set too high or too low.

· Adjust nozzle height (see page 14).

 

· Hose kit cap missing.

· Check for hose kit cap.

 

· Clogged nozzle or exhaust.

· Unclog nozzle or exhaust (see page 5)

 

· Excessive quantity of debris.

· Allow air to feed with debris.

 

 

 

Abnormal vibration.

· Loose or out of balance impeller.

· Check impeller and replace if required.

 

· Loose engine.

· Check engine.

 

 

 

Engine will not start.

· Throttle in off position.

· Check throttle control (see page 13).

 

· Engine not in full choke position.

· Check throttle, choke position (see page 13).

 

· Out of gasoline or bad, old gasoline.

· Check gasoline.

 

· Spark Plug wire disconnected.

· Connect spark plug wire.

 

· Gas valve off.

· Turn on gas valve.

 

· Dirty air cleaner.

· Clean or replace air cleaner. Contact a qualified

 

 

service person.

 

· Safety Interlock disengaged on bag plate.

· Latch the bag properly or check the bag rod to

 

 

see if it is bent.

 

 

 

Engine is locked, will not pull over.

· Impeller plugged or clogged.

· Remove debris (see page 16).

 

· Engine problem.

· Contact an engine servicing dealer for engine

 

 

problems.

No self-propelling

· Drive clutch not engaged

· Engage the drive clutch lever.

 

· Transmission not in gear.

· Check transmission shift control (see page 16).

 

· Drive belt worn or broken

· Check the drive belt.

 

· Drive clutch cable out of adjustment or broken.

· Check the drive clutch cable (see page 20).

 

· Spring tension too loose

· Check spring legnth (see page 20).

 

· Drive chain off the sprocket.

· Check the drive chain (see page 22).

 

 

 

Self propelled drive will not release

· Improper drive clutch cable adjustment or

· Check the drive clutch cable (see page 20).

 

cable is kinked.

 

Noisy or broken chain

· No chain lubrication.

· Lubricate chain.

 

· Chain misalignment or tension.

· Check the drive chain (see page 22).

 

 

 

Form No F082206A

23

Part No 840099

Page 23
Image 23
Billy Goat MV650SPH owner manual Troubleshooting, Wiring Diagrams