page 8
Troubleshooting
The Speakerphone Caller ID must be serviced by trained |
engineers. NEVER attempt any repairs or adjustments yourself — |
you could make the problem worse and invalidate the Guarantee. |
Always make sure your Speakerphone Caller ID is fully plugged |
Speakerphone Caller ID
Model 3488 USER GUIDE
Loudspeaker |
Display
| into the telephone line socket. |
If the phone does not ring … | Check that the ringer volume switch on the side of the unit is |
| not set to the lowest position. |
| Check that the total REN value of all equipment connected to |
| your telephone line is no more than 4. Disconnect one or |
| more telephones and see whether that helps. |
If you cannot make calls … | Disconnect all other instruments connected to the same line |
| as the Speakerphone Caller ID and see whether you can make |
| a call. |
| Disconnect the Speakerphone Caller ID from the telephone |
| line and plug a different telephone into the socket. Try making |
| a call. If this works, the line is OK. |
SECRECY button
press this during a call to prevent the caller from hearing you. Press it again when you
want to be heard again.
PHONE BOOK button*
SPEAKERPHONE button — press this to dial and speak with the handset on hook.
Ringer volume control
Loudspeaker volume control
REDIAL • PAUSE button — press this to display the last number you dialled. You may need this button’s PAUSE function if your phone is connected to a PBX.
If you are using a | |
a telephone directly into the socket. If the call now works, the | |
adapter may be faulty. |
|
If you think the fault may be on the exchange line, contact | |
the service provider (the BT engineers on 151, or your cable | |
company). |
|
If you still cannot identify the cause of the problem, contact | |
the Binatone Help Line. | |
Technical details |
|
Temperature range | Operating 0ºC to 40ºC |
| Storage |
Approvals | ETS |
RECALL button | MENU buttons* | |
|
| |
You will need this if your phone Microphone |
| * While you are using these buttons for |
is connected to a PBX, or if you |
| system functions (storing numbers, etc.) |
use BT’s Select Services. |
| your phone line will be BUSY to callers. |
|
| Ignore any tones or recorded messages |
|
| from the exchange. |
|
|
|
|
|
|
Installation
Fit a battery before you connect the phone to the telephone line.
You need a 9 V PP3/6FL22 battery (not supplied with the unit).
1 | Remove the screw from the latch on the battery compart- |
| ment cover (on the underside of the unit). Squeeze the |
| latch to remove the cover |
2 | Take out the battery connection pad. Don’t pull on the |
| wires |
Do not clean any part of your Speakerphone Caller ID with solvent chemicals, abrasives or spray cleaners which might get inside the case and cause damage not covered by the guarantee. When necessary, clean it with a damp cloth.
Keep your Speakerphone Caller ID away from hot, humid conditions or strong sunlight.
PBX compatibility | 100 ms timed break recall |
| Pause length: 3 seconds |
| Signalling type: DTMF (dual tone |
| multifrequency), also called tone dialling |
The five numbers stored in the Redial memories can have up to 32 digits each.
Binatone Telecom plc operates a policy of continuous product improvement, and so reserves the right to make changes to the product and functions without notice.
If you need help, call the Binatone Help Line
0208 344 8870
9.00 am to 5.00 pm, Monday to Friday
SAFETY WARNINGS
Before removing the battery compartment cover, always make sure the telephone line cable is unplugged at the socket
Do not install the unit where it might get wet.
3 | Click the connectors on the battery firmly into the studs |
| on the pad |
4 | Place the battery in the compartment |
5 | Replace the cover and the screw, making sure it fits firmly |
| into place |
6 | Plug the telephone line cable into the socket |
| Conditions for use |
| You can connect your Speakerphone Caller ID to a public |
| exchange line in the UK; or to an extension on an approved PBX |
| using DTMF (tone) signalling and |
| The ringer equivalence numbers (RENs) of all instruments |
| connected to an exchange line must not add up to more than 4. |
| The Speakerphone Caller ID has a REN of 1; most other phones |
| and fax machines have a REN of 1 unless marked otherwise. |
