BCM3600I/IUK04M1 Visual.qxd 6/18/04 16:10 Page 7
U.K. and IRELAND
CONGRATULATIONS
By choosing a Bionaire™ humidifier, you have chosen one of the finest humidifiers on the market today.
PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS.
NOTE: Before reading these instructions, please refer to the corresponding illustrations
DESCRIPTIONS (SEE FIG 1)
A. Water Tanks
B.Humidistat C.Refill Light D.Moisture Exhaust Grills E. Power Light
F. Filter Monitor™ Indicator G.Air Intake Grills H.Humidifier Base
I. Humidifier Housing J. Control Knob
WHEEL INSTALLATION (FIG. 2)
A. Stationary Wheels
B. Swivel Wheels
FIG. 3
A. Circular Extended Life Filter
B. Circular Filter Support
C.Float Switch
D.Humidifier Base
SAFETY PRECAUTIONS
When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
•Read all instructions before using the appliance.
•To avoid fire or shock hazard, plug the appliance directly into an electrical outlet and fully insert the plug.
•Keep the cord out of heavy traffic areas. To avoid fire hazard, NEVER put the cord under rugs, or near radiator, stoves, or heaters.
•DO NOT place humidifier near heat sources such as stoves, radiators, and heaters.
Do locate your humidifier on an inside wall near an electrical outlet. The humidifier should be at least 10cm/4" away from the wall for best results.
•WARNING: Do not attempt to refill humidifier without first unplugging the unit from it's electrical outlet. Be sure to pull by the plug
and not the cord.
•NEVER drop or insert any object into any openings. DO NOT place hands, face, or body directly over or near Moisture Outlet while unit is in operation. DO NOT cover Moisture Outlet or place anything over it while the unit is operating.
•DO NOT operate any appliance with a damaged cord or plug, after the appliance malfunctions, or if it has been dropped or damaged in any manner. Return appliance to manufacturer for examination, electrical or mechanical adjustment, or repair.
•Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by The Holmes Group, may cause hazards.
•DO NOT use outdoors.
•Always place humidifier on a firm, flat, level surface. A waterproof mat or pad is recommended for under the humidifier. NEVER place it on a surface that may become damaged by exposure to water and moisture (i.e. finished floor).
•DO NOT allow the Moisture Outlet to directly face the wall. Moisture could cause damage, particularly to wallpaper.
•Humidifier should be unplugged when not in use.
•NEVER tilt, move, or attempt to empty unit while it is operating. Shut off and unplug before removing the water tank and moving the unit. DO NOT attempt to remove the water tank within 15 minutes after the humidifier is turned off and unplugged. Serious injury may result.
•This humidifier requires regular maintenance to operate appropriately. Refer to cleaning and maintenance procedures.
•NEVER use detergents, petrol, glass cleaner, furniture polish, paint thinner, or other household solvents to clean any part of the humidifier.
•Excessive humidity in a room can cause water condensation on windows and some furniture. If this happens, turn the humidifier OFF.
•Do not use humidifier in an area where humidity level is in excess of 55%.
•DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. The inside of the unit contains no user serviceable parts. All servicing should be performed by qualified personnel only.
•If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person.
2
PLEASE SAVE THESE INSTRUCTIONS
Please note that this is an electrical appliance, and requires attention when in use.
HOW YOUR COOL MIST HUMIDIFIER WORKS
Your Bionaire™ Cool Mist humidifier draws dry air through the rear air intake grill area. This air is then passed through a
NOTE: This humidification system provides a cool, invisible moisture output. It is normal not to see the mist.
NOTE: A humidity level below 20% can be unhealthy and uncomfortable.
The recommended humidity level is between
PRE-OPERATING INSTRUCTIONS
1.Be sure the Control Knob is in the OFF position and the unit is disconnected from the electrical outlet.
2.Remove housing, filter and tanks.
3.TO PROVIDE ADDITIONAL MOBILITY AND CONVENIENCE TO YOUR CONSOLE HUMIDIFIER, install the wheels. Remove the four wheels located in a small pouch in the box. Turn the base upside down, and locate the holes at each of the four corners on the underside. NOTE: You will notice that there are two different shaped wheels. Two of the 4 wheels are stationary wheels and two are swivel type wheels.
The stationary wheels are identified by a flat top surface, while the swivel type are curved and include a small plastic piece on the shaft. See figure 2 for installation location for each type of wheel. DO NOT use any tools to install the wheel because tools may damage the base of the unit. Return the base to the upright position.
4.Replace filter, housing and tanks.
5.Choose a location out of reach of children. DO NOT place the humidifier on a finished floor or near furniture which can be damaged by moisture or water.
Filling the Water Tank
NOTE: This humidifier holds about 13 litres of water in the tank and humidifier base. The humidifier will produce up to 34 litres of moisture over a
1.Remove the two tanks from the base of the humidifier and bring each tank to the faucet. Turn the tanks upside down and twist off the tank caps by turning
Fill each tank with cool, fresh tap water. Replace the cap on each tank FIRMLY.
2.When full, carry each tank to the humidifier and place onto the base (use both hands when carrying each tank). Each tank holds 6 litres of water, and the base holds 0.9 litre of water.
3.Plug the power cord into the electrical outlet.
OPERATING INSTRUCTIONS
With housing placed properly onto the base, the filter installed correctly, the tanks filled and the plug correctly inserted in the outlet, you are now ready to operate the humidifier.
NOTE: The BCM3600 produces clean, cool, INVISIBLE moisture.It is normal not to see the moisture.
1.Turn the Control Knob to the HI position and turn the Humidistat to HI.
2.Allow up to 30 minutes for the filter to fully absorb water and the unit to produce the maximum moisture output.
3.Adjust the
4.The Automatic Humidistat Control is designed to operate between 25% and 60% Relative Humidity range. The recommended setting is between 40% and 50%. When the humidity level in the room is below the level you have set, the humidifier will operate to produce moisture. When the set humidity level in the room is reached, the humidifier will stop. When the humidity again drops below the set level, the unit will automatically start and produce moisture again.
NOTE: We recommend the use of the hygrometer which reads the actual humidity level in your room. A humidity level below 20% can be unhealthy and uncomfortable. The recommended humidity level is between 40% and 50%.
5.When the water level is low, the refill light will illuminate to indicate the unit needs refilling. Shut off and unplug the unit.
NOTE: THE FAN WILL CONTINUE TO RUN TO ALLOW THE HUMIDIFIER TO DRY OUT AND PREVENT ALGAE GROWTH.
6.Before refilling, follow Daily Maintenance Instructions and check to see if the filter needs replacing by comparing it to the
7.Refill water tanks.
8.Plug into the electrical outlet. Turn the Humidity Control Knob to the HI ( III ), MED ( II ), or LOW ( I ) setting.
NOTE: If moisture forms on the walls or windows, turn off the humidifier.
3
