Installing System Memory | BioStar P4M800 manual

P4M800 Pro-M7

2.3INSTALLING SYSTEM MEMORY

DDR2_A1

1.Unlock a DIMM slot by pressing the retaining clips outward. Align a DIMM on the slot such that the notch on the DIMM matches the break on the Slot.

2.Insert the DIMM vertically and firmly into the slot until the retaining chip snap back in place and the DIMM is properly seated.

8

Image 10

BioStar P4M800 manual Installing System Memory

Contents

FCC Information and Copyright Table of Contents Chipset DimensionFeatures Operating Systems 10/100 LAN PHY Super I/OOn Board IDE Serial ATA Front Side Onboard Peripherals Rear Side ConnectorsPackage List LGA775 Hardware Installation Installing Central Processing Unit CPU Step JCFAN1 CPU Fan Header FAN Headers Installing System Memory FDD1 Floppy Disk Connector Connectors and Slots PCI1~PCI3 Peripheral Component Interconnect Slots CNR1 Communication Network Riser Slot HOW to Setup Jumpers JUSBV1/JUSBV2 Power Source Headers for USB portsDetail Settings JATXPWR1 ATX Power Source Connector JATXPWR2 ATX Power Source Connector JUSB2/JUSB3 Headers for USB 2.0 Ports at Front Panel JPANEL1 Front Panel Header JCDIN1 CD-ROM Audio-in Connector JFAUDIO1 Front Panel Audio Header JCMOS1 Clear Cmos Header JCI1 Chassis Open Header JSATA1~JSATA2 Serial ATA Connectors JSPDIFO1 Digital Audio-out Connector Award Bios Beep Code Bios UpdateExtra Information CPU Overheated Troubleshooting Problem Solution Introduction System Requirement Installation Tray Icon Warpspeeder Includes 1 Tray Icon and 5 Panels Main Panel contains features as follows Main Panel Voltage Panel Overclock Panel contains the these features Overclock Panel Hardware Monitor Panel About Panel P4M800 Pro-M7