Maintenance and care
Hose cleaning
1.Before turning off the SpotBot, suction up clean water to thoroughly rinse out the inside of the vacuum flex hose. Then, lift the vacuum flex hose upwards to drain any remaining water into the dirty tank.
2.Disconnect the cleaning tool from the vacuum flex hose by pushing down on the button lock and pulling straight off (do not twist tools to remove them).
3.Once the tool is removed from the vacuum flex hose it can be cleaned by rinsing under clean running water.
Storage
1.Unplug the power Cord from the outlet. Wrap power cord around the cord wrap.
2.Empty and rinse the dirty/collection tank after each use, or when dirty water reaches the indicated maximum fill line. To remove the tank, lift up the dirty tank latch and pull the tank out. Dump out the dirty water and rinse with clean. Replace the tank into the unit for storage. After using the SpotBot’s handsfree feature, wipe the window and brushing area with a soft cloth.
3.If you were using your SpotBot manually, wrap the vacuum flex hose around the unit and secure the spray trigger into the receiver on the front of the unit.
4.Store unit indoors at room temperature (40° to 110°F).
Tip:
If a significant amount of water and solution(s) remain in the clean tank, your unit can be stored with liquid in the clean tank. However, if you have added Oxy GEN2 into the clean tank, fresh Oxy GEN2 should be added prior to the next use to optimize performance.
w w w . b i s s e l l . c o m
Tip:
Clean out the Black Valve periodically inside of the Dirty/Collection Tank.
8 0 0 . 2 3 7 . 7 6 9 1 | 11 |
10/14/08 1:07:48 PM |
