Bissell 1200, 7887 warranty To begin cleaning, Handsfree cleaning, Operation

Operation

To begin cleaning

1.Plug your SpotBot in. The Power light will illumi- nate instructing you that there is power to the unit and it is ready to go.

2.Place the filled Clean/Solution tank on to the unit

Handsfree cleaning

1.Place the unit directly over the spot or stain, making sure the stain is in the center of the handsfree cleaning area.

2.Select which cleaning cycle (surface stain or set-in) you would like to begin with. Your SpotBot will begin spraying, brushing and suctioning up the spots and stains, in its pre-programmed cycle. Both cycles have been tested and proven to deliver superior cleaning results, taking the guesswork out of cleaning for you.

3.When the cleaning cycle you have selected is complete, the SpotBot will beep. The beep will continue until you hit the STOP button.

4.Pick up the unit and check the area that was cleaned.

5.If you have used Oxy GEN2, this chemical will continue to work for the next six to eight hours. Cleaning your spots and stains all the way to the backing of the carpet.

w w w . b i s s e l l . c o m

Tip:

Some difficult stains may require that you run the cleaning cycle a second time.

8 0 0 . 2 3 7 . 7 6 9 1 9

ug120-4070_1200_408.indd 9 10/14/08 1:07:44 PM