Bissell 1200, 7887 warranty Manual/hose cleaning, 12a 2b3, Operation

Models: 1200, 7887

1 16
Download 16 pages 10.53 Kb
Page 10
Image 10
Manual/hose cleaning
8 0 0 . 2 3 7 . 7 6 9 1

Operation

Manual/hose cleaning

1.Remove the hose from the unit by depressing the release button.

2.a. Remove the Tough Stain Brush from the back of the unit.

b. Attach the Tough Stain Brush onto the grip of the flex hose.

3.Select the manual/hose button on the control panel to start the SpotBot.

NOTE: In manual mode, the SpotBot will not turn on until the grip is removed from the unit. If it is not removed within 30 seconds of pushing the start button, the unit will shut off.

4.Begin cleaning by holding the tool no more than six inches above the soiled surface. Depress the spray trigger for about

5 seconds to apply the cleaning solution to the soiled area. Release the trigger. Be careful not to over wet.

5.Using the brush on the tool, gently scrub the soiled area for about 30 seconds or until the soiled area appears to be clean.

6.To suction up the dirt and cleaning solution, position the suction nozzle over the cleaned area, apply downward pressure on the tool, and pull nozzle toward you. You should see the dirty solution pass through the nozzle. Continue until no more solution can be removed. Normally, this step will require no more than one minute of back and forth passes.

NOTE: In manual mode, the SpotBot is equipped with a safety feature which will shut the unit off after 30 minutes. Press start to resume cleaning.

7.If the stain is still visible, repeat steps 4-6 as necessary.

8.When the cleaning is complete, lightly drag the suction nozzle across the stain for about two minutes to further aid in drying the cleaned area.

9.Press the Manual/Hose button to turn off the SpotBot.

10.Unplug the machine, wrap the cord on the

cord wraps and wrap the hose around the machine so that the wand can be placed in the holder for convenient storage. 2.a. Remove the Tough Stain Brush from the back of the unit.

10 w w w . b i s s e l l . c o m

12a

2b3

Tip:

One of the effective stain removing ingredients in Oxy Gen2 is Hydrogen Peroxide. Certain people may be affected by the product when it comes into contact with their skin; it may turn the skin white and/or cause tingling. Washing your hands after use and applying hand lotion will remove any possible white discoloration.

Tip:

Check upholstery stuffing before cleaning. Colored stuffing may bleed through the fabric when it becomes wet.

ug120-4070_1200_408.indd 10

10/14/08 1:07:47 PM

Page 10
Image 10
Bissell 1200, 7887 Manual/hose cleaning, 12a 2b3, Operation, 2. a. Remove the Tough Stain Brush from the back of the unit