Bissell 1694 Cleaning Bare Floors Continued, Bare Floor Cleaning Technique, Machine Preparation

Cleaning Bare Floors Continued

Machine Preparation

Set up machine following instructions in the The Basics

1. section, pages 6-8. Be sure to thoroughly rinse out any remaining Fibre Cleansing Formula from the Tank-in-Tank to prevent slippery linoleum, vinyl, and tile floors.

Use BISSELL Floor Cleansing Formula in the

Tank-in-Tank.

2.

3.

Check ReadyTools dial - it should be set on Floor Cleaning.

Plug into a proper outlet and turn Power Switch on.

Bare Floor Cleaning Technique

Slowly move the machine nozzle with Bare Floor Tool

1. forward and back over soiled surface one time while pressing the trigger. Caution: Do not over wet.

Repeat the motion without pressing the trigger using the

2. Bare Floor Tool to squeegee and suction up the dirty water.

3.

4.

Repeat steps 1 and 2 backing along the exit path.

Allow about 30 minutes for the floor to dry completely.

When the cleaning job is complete refer to the

5. Maintenance/Storage section on page 14-16.

To remove Bare Floor Tool gently bend long tab (right side)

6. outward and pull tool down away from nozzle. Rinse thoroughly, dry and store.

13