Nikon COOLPIXS100RED Cleaning, Storage, Do not use alcohol, thinner, or other volatile chemicals

Maximizing Camera Life and Performance

Cleaning

Do not use alcohol, thinner, or other volatile chemicals.

	Avoid touching glass parts with your fingers. Remove dust or lint with a blower
	(typically a small device with a rubber bulb attached to one end that is
	pumped to produce a stream of air out the other end). To remove fingerprints
	or other stains that cannot be removed with a blower, wipe the lens with a soft,
Lens	dry cloth or a cloth for cleaning glasses, using a spiral motion that starts at the
	center of the lens and working toward the edges. Wiping with too much force
	or with a hard cloth may damage the lens or cause it to malfunction. If dust or
	lint still remains, clean the lens using a cloth lightly dampened with
	commercial lens cleaner.
	Remove dust or lint with a blower. To remove fingerprints and other stains,
Monitor	wipe the monitor with a soft, dry cloth or a cloth for cleaning glasses, being
	careful not to apply pressure. Wiping with too much force or with a hard cloth
	may damage the monitor or cause it to malfunction.
	Use a blower to remove dust, dirt, or sand, then wipe gently with a soft, dry
	cloth. After using the camera at the beach or other sandy or dusty
Body	environment, wipe off any sand, dust, or salt with a dry cloth lightly dampened
	with fresh water and dry thoroughly. Note that foreign matter inside the
	camera could cause damage not covered by the warranty.

Storage

Turn the camera off when not in use. Be sure that the power-on lamp is off before putting the camera away. Remove the battery if the camera will not be used for an extended period. Do not store the camera with naphtha or camphor moth balls, or in any of the following locations:

•Next to equipment that produces strong electromagnetic fields, such as televisions or radios

•Exposed to temperatures below –10°C (14°F) or above 50°C (122°F)

•Places that are poorly ventilated or subject to humidity of over 60%

To prevent mold or mildew, take the camera out of storage at least once a month. Turn the camera on and release the shutter a few times before putting the camera away again.

For storing the battery, follow the precautions in “The Battery” (F3) in “Maximizing Camera Life and Performance”.

Technical Notes and Index

F5