Bissell 1716 Operations, Filling the solution tank, Pre-treating, Cleaning, back on the unit

Operations

Filling the solution tank

1.	Remove the solution tank by gently pressing	1.
	the quick release tabs on the solution tank
	and sliding the tank off of the unit.
2.	Open the tank by unscrewing and remov-
	ing the cap. Add water and formula* to the
	indicated fill lines on the solution tank.
	*NOTE: Your Spot Lifter PowerBrush
	includes an 8 oz. trial size formula.
3.	Replace the cap before placing the tank	2.
	back on the unit.

Pre-treating

To aid in the removal of tough, stubborn stains, pre-treating the stain may be necessary.

1.Hold the unit above the area to be cleaned. Using the manual trigger spray, apply a sufficient amount of water and solution to the stain.

2.Wait 3-5 minutes before cleaning.

Cleaning

1.	Plug in the unit.
2.	While holding the Spot Lifter PowerBrush above
	the area to be cleaned, apply water and formula	2.
	by pressing the manual trigger spray,
	dispensing fluid to the soiled/stained area.

3. Turn the power switch to the “ON” position. ( I )

4. Brushing and suction can be done separately, based on how you hold and use the unit.

To Use The Dual PowerBrushes Only:	3.
Tilt the unit forward slightly, placing both brushes
in contact with the carpet. The flat surface of the
brush cartridge should be parallel to the surface
being cleaned.

For Suction Only:

Tilt the unit forward, pressing the front of the Spot Lifter Powerbrush firmly against the sur- face area to be cleaned, lifting the brushes up off the surface. Pull toward you to remove the soil and cleaning solution.

Note: Step #4 may be repeated until no more dirty water is removed or until the area to be cleaned meets your satisfaction.

6 w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1