Maintenance and care
Machine care
1.Turn the power switch to the “OFF” position. ( O )
2.Unplug the unit.
3.Carry the Spot Lifter PowerBrush to the sink or drain.
To empty the collection tank
1.Begin by removing the solution tank. Gently press the quick release tabs on the solution tank and slide the tank off of the unit.
2.Grasp the collection tank and pull to remove.
3.While at the sink, remove the tank cap by unscrewing and lifting out.
4.Empty the tank. Rinse the collection tank with warm water.
5.Replace cap by turning to the right, until snug.
6.Slide the collection tank into the unit. Replace the solution tank.
Note: If a significant amount of water and formula remains in the solution tank, you may leave it in the solution tank for your next cleaning task.
To clean the dual powerbrush
NOTE: Make sure the Power Switch is in the “OFF” ( O ) position and the unit is unplugged.
1.Firmly grasp the brush cartridge from the side of the unit and pull out from the unit.
2.To remove any debris that may have collected around the dual PowerBrushes, rinse the brush cartridge under
warm water.
3.Replace the brush cartridge into the unit by gently guiding the cartridge in the unit. Once it is in place, firmly “snap” the brush cartridge in place.
NOTE: Do not attempt to remove or insert the brush cartridge while the unit is running. This will damage your unit.
1.
2.
3.
1.
2.
8 w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
