Attaching the Bare Floor Tool Continued*
*Available with select models only.
1. | Remove Dirty Water Tank. | ||
2. | Remove Brush by depressing tabs on the Cross Action™ Brush | ||
outward with thumbs until the Brush loosens. | |||
3. | Add Bare Floor Tool underneath the Floor Nozzle by sliding | ||
notches and tabs into the opening until it is secure. Make sure | |||
| tabs on the Bare Floor Tool snap over front lip of | ||
| Floor Nozzle. | ||
4. | Replace empty Dirty Water Tank. | ||
5. | Empty and rinse Clean Water Tank. | ||
6. | Using the Formula Measuring Cap, add two (2) capfuls of | ||
BISSELL® Floor Cleansing Formula™ to the Clean Water Tank. | |||
| Add | ||
| line – do not overfill. | ||
7. | Turn Formula Measuring Cap clockwise until secure. | ||
8. | Rotate Quick Release Cord Wrap™ and plug in. | ||
9. | Turn Power Switch [back of Lower Body] to ( |
| ) ON. |
| |||
|
Cleaning Bare Floors
WARNING:
The Dirty Water Tank holds approximately 1/2 gallon of soiled liquid. Filling past the fill line can damage unit.
Floor
nozzle
front lip
Tabs
Bare Floor Tool
Cross Action™ Brush
1. | Slowly move QuickSteamer back and forth over soiled surface |
| one time while depressing Trigger. Do not overwet. |
2.
3.
4. If Floor Nozzle stops spraying, turn Power Switch to
OFF ( ) and check water and cleaning solution levels. Refill if needed.
WARNING:
Do not lay QuickSteamer on its back with Clean Water Tank in place. Do not tip up foot with Dirty Water Tank in place.