Bissell 1950 Pre-Treating Optional, Deep Cleaning, Attaching the Bare Floor Tool, carpet life

Pre-Treating (Optional)

				Pre-treat stubborn stains and highly soiled carpet in
				hallways and other high-traffic areas.
				Spray soiled area with BISSELL® Tough Stain PreCleaner.™
		1.
				Use a stiff-bristled brush to work formula into carpet pile.
	2.
				Wait 3 -5 minutes before deep cleaning.
			3.
			Deep Cleaning
1.				Turn Power Switch [back of Lower Body] to (	) ON.
2.				With foot, press the Detent Pedal on right side of Lower Body.
3.				Depress Trigger to spray cleaning solution. Do not overwet.
4.				Repeat motion over same area without depressing Trigger.
5.				Repeat Steps 3 and 4 until no more dirt can be removed.
6.				Continue to clean entire carpet, working in 3’ x 4’ sections.
7.				Empty the Dirty Water Tank when dirty water reaches the full
				line, or when the Clean Water Tank is empty.
8.				If Floor Nozzle stops spraying, turn Power Switch to
				OFF ( ) and check water and cleaning solution levels.

Refill if needed.

Tip:

Deep cleaning spots, spills and high traffic areas on a regular basis can prolong

carpet life.

Tip:

Deep cleaning carpeting regularly can reduce dust and allergens in your home.

7.

Dirty Water Tank

Attaching the Bare Floor Tool

*Available with select models only. If your QuickSteamer did not come so equipped, you may call BISSELL Consumer Services at 1-800-237-7691 to order one. You can also visit the BIS- SELL website: www.bissell.com.

NOTE: Your QuickSteamer is not recommended for cleaning wood floors.

•Use only BISSELL® Floor Cleansing Formula™ on no-wax floors. Never use BISSELL Fiber Cleansing Formula™ or other carpet cleaners on bare floors.

•Sweep or vacuum before starting.

•Remove old wax before cleaning.

•Leave an exit path for yourself.

•Allow at least 1/2 hour drying time.

Bare Floor Tool

(select models only)