Bissell 28F4, 80E7 warranty Maintenance and care, Emptying dirt container, Full Line, Unlock

Maintenance and care

To maintain maximum cleaning performance from your BISSELL Cleanview cyclonic bagless vacuum, perform these simple maintenance steps.

1.Empty the dirt container when the dirt reaches the “Full” line on the side.

2.Check the inner and outer circular filters, and the pre-motor filter at least once a month and clean or replace as needed.

3.Replace the HEPA media post-motor filter* every three to six months.

Note: More frequent filter cleaning or replacing may be necessary if you are vacuuming new carpet, fine dust, or have allergy concerns. Follow the instructions on the fol- lowing pages to perform these simple maintenance steps.

Emptying dirt container

The dirt container needs to be emptied when the dirt reaches the “Full” line on the side of the container.

1.Unplug cleaner from electrical outlet.

2.Slide the Lock ‘n Seal lever to the "Unlock" position.

3.Grasp handle and pull dirt container straight out to remove from vacuum.

4.Empty dirt into garbage container.

5.Put dirt container back in the vacuum and slide the lever to the "Lock" position.

Note: The dirt container may be washed in warm water with a mild detergent. Remove the filter cup from the bottom before washing. Make sure it is completely dry before reassembling with the filter cup.

WARNING:

To reduce the risk of electric shock, turn power switch OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks.

Tip:

For maximum cleaning performance, check and clean or replace all filters as suggested.

		Full Line
Unlock
	Lock Position
Position

*The Filter Media, not the vacuum as a whole, complies with the High Efficiency Particulate Air (HEPA) filter specification (EN 1822-1:2009).

8w w w . b i s s e l l . c o m