Troubleshooting
Vacuum cleaner won’t run
Possible Causes
1Power cord not plugged in
2Blown fuse/tripped breaker
WARNING:
To reduce the risk of injury from moving parts and/ or electrical shock, turn Power Switch OFF and disconnect polarized plug from electrical outlet before performing troubleshooting checks.
Remedies
1Check electrical plug
2Check/Replace fuse or reset breaker
Vacuum cleaner or Tools won’t pick up dirt
Possible Causes
1Incorrect Height Adjustment
2Hose not attached to suction opening
3Twist ‘n Snap Hose not securely attached
4Crack or hole in Hose
5Broken or worn Drive Belt
6Rotating Floor Brush bristles worn
7Rotating Floor Brush jammed
8Clog in vacuum
9Dirt Container full
10Dirt Container or Upper Tank not installed properly
11Filters are dirty
Remedies
1Adjust Powerfoot to correct height
2Firmly push Hose Wand into the suction opening
3Make sure Twist ‘n Snap Hose is snapped into locked position
4Check Hose and replace if needed
5Replace Drive Belt, see page 12
6Replace brush
7Remove brush and clean debris from brush ends
8Clear clog, see pages
9Empty Dirt Container
10Position correctly and lock in place
11Check and clean Upper Tank,
Vacuum cleaner is difficult to push
Possible Causes | Remedies |
1 Incorrect Height Adjustment | 1 Adjust Powerfoot to correct height setting |
Visible dirt escaping from cleaner
Possible Causes
1Dirt Container full
2Filters missing or installed incorrectly
3Dirt Container installed incorrectly
Remedies
1Empty Dirt Container
2Check Upper Tank,
3Pull out and
Clean Carpet Sensor not functioning properly
Possible Causes
1Clean Carpet Sensor Lens is Dirty
2Clog in Suction Intake Area
Remedies
1Clean Internal Sensor Lens, see page 10
2Clear clog, see pages
14
