Attach Vacuum Hose and Tools
1. Position the Hose Assembly on the back of the vacuum as shown.
2. Attach the Hose with the remaining two screws from the packet. Tighten securely with a screwdriver.
For Models with the Twist ‘n Snap™ Hose
1a Position the Twist ‘n Snap Hose assembly on the back of the vacuum.
2a Line up the tabs on the base of the Twist ‘n Snap Hose with the corresponding notches on the hose collar as shown.
3a Turn the Twist ‘n Snap Hose to the right to lock the hose into place.
3.Grasping the Quick Reach Handle, slide the end of
the Hose Wand onto the Hose Wand Base. Snap the | Twist ‘n Snap Hose Models | |
Hose into the Hose Clip. | ||
|
NOTE: The Powerfoot will not operate effectively unless the Hose Wand is firmly attached.
4.Slide the Extension Wand and the Crevice Tool
together into the storage clip as shown.
5. Slide the Dusting Brush/Upholstery Tool into the storage clip as shown.
6.Attach the TurboBrush by aligning the small holes near the brush roll with the tabs at the bottom of TurboBrush hous- ing. Snap TurboBrush into place as shown.
Select Models Only
NOTICE:
The Floor Brush will continue to rotate while you use your vacuum for above floor cleaning. To prevent carpet damage, do not lean on the vacuum or let the Powerfoot tilt forward.
CAUTION:
Before using your vacuum, make sure that the Dirt Container and Upper Tank are in locked position and that all filters (UpperTank,
6
