How To Maintain Your Vacuum
To maximize your cleaning performance and extend the life of your vacuum, it is very important that you empty your dirt container and check and clean your filters fre- quently. Perform the following maintenance steps:
1.Empty the Dirt Container when the dirt reaches the “Full” line on the side.
2.Check the Upper Tank and
3.Clean or replace the
Note: More frequent filter cleaning may be necessary if you are vacuuming new carpet, fine dust, or have allergy concerns. Follow the instructions on the following pages to perform these simple maintenance steps.
WARNING:
To reduce the risk of electric shock, turn Power Switch OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.
Tip:
For maximum cleaning performance, check and clean or replace all filters as suggested.
Empty Dirt Container
The Dirt Container needs to be emptied when the dirt | Unlock |
|
reaches the “Full” line on the side of the Container. |
| |
| ||
1. Unplug cleaner from electrical outlet. | Position | |
|
| |
2.Slide the Lock ‘n Seal Lever to the "Unlock" position.
3.Grasp handle and pull the Dirt Container straight out to remove from vacuum.
4.Empty dirt into garbage container.
5.Put the Dirt Container back in the vacuum and slide the lever to the "Lock" position.
Note: The Dirt Container may be washed in warm water with a mild detergent. Make sure it is completely dry before using again.
Clean Carpet Sensor
Full Line
Lock Position
To maintain the effectiveness of the Clean Carpet Sensor, a quarterly cleaning of the internal sensor lens is recommended. To clean the sensor lens, detach the Twist ‘n Snap Hose and gently wipe the clear lens area using a lightly dampened soft cloth. Allow enough time for the lens to dry thoroughly before reattaching the Twist ‘n Snap Hose and using the vacuum.
10
