Check Rotating Floor Brush and Drive Belt Continued
4.Grasp Rotating Floor Brush at both ends and lift.
5.Clean strings, hair and other debris from Rotating Floor Brush, paying particular attention to brush ends.
6.Clean strings, hair and other debris from Motor Pulley and Drive Belt areas.
7.Check Drive Belt carefully for wear, cuts or stressed areas.
8.Check Air Passageway for obstructions. Remove debris from this area.
Replace Drive Belt
1.Unplug cleaner from electrical outlet.
2.With Rotating Floor Brush removed from vacuum cleaner (Steps
Discard old Drive Belt.
3.Place new Drive Belt over Motor Pulley and stretch other end over Rotating Floor Brush in the space between the bristles.
4.Place ends of Rotating Floor Brush down into slots on sides as shown.
5.Turn Rotating Floor Brush by hand several times in the direction of Motor Pulley. If properly installed, Drive Belt will centre itself on Rotating Brush crown.
6.Reposition Brush Cover and screw or snap back into place. Check to be sure all screws or latches are secure.
Replace Lightbulb
1.Unplug cleaner from electrical outlet.
2.Using a screwdriver, remove the two screws as shown and lift off the lens.
3.Remove the bulb from the socket by grasping bulb and pulling straight out. Install the new bulb by pushing it gently into the socket until the bulb snaps into place.
4.Reposition lens and secure with the two screws.
Maintaining TurboBrush
Select Models Only
The TurboBrush should be checked regularly for clogs or debris wrapping around the brush roll.
1. | Unplug vacuum from electrical outlet. | |
| ||
2. | If a clog is present or debris is visible, unscrew the two | |
screws on the back of the TurboBrush to remove the | ||
| ||
| faceplate and clear any obstructions. | |
3. | To clean debris from the brush roll, remove the screw | |
located by the brush roll with a Phillips head screwdriver. | ||
|
Motor Pulley
Air Passageway
12
Lift the belt cover. Remove the brush roll from the drive belt and clean debris.
