How To Maintain Your Vacuum
To maximize your cleaning performance and extend the life of your vacuum, it is very important that you empty your dirt container and check and clean your filters frequently. Perform the following maintenance steps:
1.Empty the Dirt Container when the dirt reaches the “Full” line.
2.Check the Upper Tank and
3.Clean or replace the
Note: More frequent filter cleaning may be necessary if you are vacuuming new carpet, fine dust, or have allergy concerns. Follow the instructions on the following pages to perform these simple maintenance steps.
WARNING:
To reduce the risk of electric shock, turn Power Switch OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.
Tip:
For maximum cleaning performance, check and clean or replace all filters as suggested.
Empty Dirt Container
The Dirt Container needs to be emptied when the dirt reaches the “Full” line on the Container.
1.Unplug cleaner from electrical outlet.
2.Slide the Lock ‘n Seal Lever to the "Unlock" position.
3.Grasp handle and pull the Dirt Container straight out to remove from vacuum.
4.Empty dirt into garbage container. The Screens may also be removed from the side Dust Chambers when you empty or clean the Dirt Container. The Screens are made to fit each Dust Chamber. If they do not slide down completely, try in the opposite Dust Chamber. The Screens will also not fit if there is debris in the track.
5.Put the Dirt Container back in the vacuum and slide the lever to the "Lock" position.
Note: The Dirt Container and Screens may be washed in warm water with a mild detergent. Make sure it is completely dry before using again.
Full Line
Unlock 
Lock Position
Position
Screen 
Clean Carpet Sensor
To maintain the effectiveness of the Clean Carpet Sensor, a quarterly cleaning of the internal sensor lens is recommended. To clean the sensor lens, detach the Twist ‘n Snap Hose and gently wipe the clear lens area using a lightly dampened soft cloth. Allow enough time for the lens to dry thoroughly before reattaching the Twist ‘n Snap Hose and using the vacuum.
10
