Operations

Portable spot cleaning mode continued

Cleaning with Deep Reach™ Tool

1.Set tool on soiled surfaces and press the trig- 1. ger to spray solution onto the soiled area to be cleaned.

2.Slowly move the tool back and forth over the soiled surface, keeping the tool in con- tact with the carpet.

Release trigger and move tool slowly

3.

 

over the soiled area to suction up water

 

and dirt.

 

4.Continue to clean the area, working in small sections, until no more dirt can be removed.

Empty dirty tank

Follow the instructions under Empty

 

dirty tank section on page 9 of the

 

Upright cleaning mode section.

1.

Replacing portable machine on base

1. Align the product as the graphic shows, with the cord side on the left and hose side on the right.

2. Push down the portable spot cleaner until you hear it click securely into place. Test the fit by pulling up on the carry handle to make sure it is secure.

Cleaning portable machine

Graphic

1.Remove and rinse the tools in clean, run- ning water. Dry and replace in the tool storage provided.

2.It is recommended that you suction clean water from a bowl to rinse out the hose. Then lift end of hose and stretch out to ensure all water is cleared from hose.

3.Coil flex hose around the hose wrap and secure with latch.

4.Check suction gate and if it appears dirty, follow steps 1-4 under Cleaning Suction Gate on page 13.

12

Page 12
Image 12
Bissell 35K3, 94Y2, 27F6, 73H5 Replacing portable machine on base, Cleaning portable machine, Cleaning with Deep Reach Tool