Check Rotating Brush and Drive Belt
You should check your vacuum cleaner’s Rotating Floor Brush and Drive Belt regularly for wear or damage. You should also clean the Brush and Brush Ends of strings, hair, and carpet fibres. These can wrap around the Brush and hamper its ability to effectively clean your carpet. Also remove any debris that has accumulated under the Brush Cover.
CAUTION:
To reduce the risk of injury from moving parts, turn Power Switch OFF and disconnect
1.
Unplug cleaner from electrical outlet.
plug from electrical outlet.
2. Remove Detachable Cylinder from vacuum cleaner.
Recline Handle and turn vacuum cleaner over so bottom
3. side is up.
Remove the six screws as shown with a Phillips
4. head screwdriver. Lift the Brush Cover off.
5.
Grasp Rotating Floor Brush at both ends and lift.
Clean strings, hair and other debris from Rotating Floor
6. Brush, paying particular attention to Brush Ends.
Clean strings, hair and other debris from Motor Pulley
7. and Drive Belt areas.
8. | Check Drive Belt carefully for wear, cuts or |
|
|
stressed areas. | Motor Pulley | Air Passageway | |
|
|
Check Air Passageway for obstructions. Remove debris
9. from this area.
11
