Attach Vacuum Hose and Tools Continued
Slide the end of the Hose Grip onto the Hose Grip Base.
3. Place the Hose into the Hose Clip.
NOTE: The Powerfoot will not operate effectively unless the Hose is firmly attached to the base.
Snap the Telescoping Extension Wand, Crevice Tool, and
4. Combination Tool into the storage clips as shown.
How To Use Your BISSELL
Power Cord Quick Release
The Power Cord is stored at the side of the Detachable Cylinder, wrapped around two Cord Wraps.
Rotate the Upper Cord Wrap toward floor and slip the
1. Power Cord off.
2. Plug into an electrical outlet.
To keep the Power Cord out of your way while cleaning,
3. place it in the Cord Clip, located near the top of the Handle.
Power Switch/Brush Switch
Combination
Tool
Crevice Tool | Telescoping | |
Wand | ||
|
CAUTION:
Before using your vacuum, make sure that the Dirt Container and Upper Tank are in locked position and that all Filters (Upper Tank,
Quick Release
Cord Wrap
The Power Switch is located just below the Handle on the front of |
|
| |
the Detachable Cylinder. Push the rocker switch “ON” (I) to |
|
| |
vacuum, and “OFF” (O) when cleaning is complete. |
|
| |
The Brush Switch is located just below the handle on the front of |
|
| |
the Detachable Cylinder next to the Power Switch. This switch |
|
| |
turns the Rotating Brush on and off. The Brush Switch should be |
|
| |
in the “ON” (I) position for normal carpet cleaning. You may want |
|
| |
to turn the Brush Switch “OFF” (O) for bare floor cleaning or other |
|
| |
delicate surfaces. |
|
| |
| Brush | ||
NOTE: Your BISSELL Lift Off vacuum is equipped | Power | ||
| |||
with a special internal switch that turns the |
| ||
|
| ||
Rotating Brush off whenever the unit is in the |
|
| |
Upright position. |
|
|
Handle Positions
1. Upright – For storage and above floor cleaning with tools.
Normal Cleaning – Press the Handle Release Pedal with
2. your foot to recline.
6
