Bissell 3760 How to Maintain Your Bissell Lift-Off Spinpower, Cleaning The Upper Tank & Filter

How to Maintain Your BISSELL Lift-Off Spinpower

To maintain maximum cleaning performance, the following maintenance steps must be performed:

1.Empty the Dirt Container when the dirt reaches the “Full” line on the front.

2.Check the Upper Tank and Pre-Motor Filters at least once a month and clean and replace as needed.

3.Replace the HEPA Media Post-Motor Filter every six months.

NOTE: More frequent Filter cleaning may be necessary if you are vacuuming new carpet, fine dust, or have allergy concerns.

Follow the instructions on the following pages to perform these simple maintenance steps.

Empty Dirt Container

WARNING:

To reduce the risk of electric shock, turn Power Switch OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks.

Tip:

For maximum cleaning performance, check and clean or replace all Filters as suggested.

The Dirt Container needs to be emptied when the dirt reaches the “Full” line on the front of the Container.

1.	Unplug cleaner from electrical outlet.
2.	Slide the Lock ‘n Seal Lever to the “Unlock” position.
3.	Grasp handle and pull the Dirt Container straight out to	Unlock
	remove from vacuum.
4.	Empty dirt into garbage container.	Position

5.Put the Dirt Container back in the vacuum and slide the lever to the “Lock” position.

Note: The Screens may also be removed from the side Dust Chambers when you empty or clean the Dirt Container. The Screens are made to fit each Dust Chamber. If they do not slide down completely, try in the opposite Dust Chamber. The Screens will also not fit if there is debris in the track.

The Dirt Container and Screens may be washed in warm water with a mild detergent. Make sure they are completely dry before replacing.

Full Line

Lock

Position

Screen

Cleaning The Upper Tank & Filter

Use only BISSELL Style 8 Replacement Filters in your

BISSELL Lift-Off Spinpower.

1.Unplug the cleaner from electrical outlet.

2.The Upper Tank Filter can be reached by removing the Dirt Container, reaching underneath the Upper Tank and turning the rim of the Filter Frame to unlock. Pull straight down to remove. Brush the dirt off the Louvers and Upper Tank Filter.

3.The foam Upper Tank Filter may be removed and hand washed in cold water with mild detergent. Rinse well then air dry thoroughly before replacing.

4.The Upper Tank and Louvers may also be wiped clean with a damp cloth.

	Note: For easier access, the entire Upper Tank may be
	removed by turning the knob on the back of the cleaner to
10	unlock and pulling the entire tank straight out.

Upper

Tank

Knob

ug603-5570_3760E_1105.indd 10

2/2/06 4:12:17 PM