Troubleshooting
Vacuum cleaner won’t run
Possible Causes
1Power cord not plugged in
2Thermal protector activated
WARNING:
To reduce the risk of injury from moving parts and/or electrical shock, turn Power Switch OFF and disconnect plug from electrical outlet before performing trouble- shooting checks.
Remedies
1Check electrical plug
2Allow cleaner to cool for 30 minutes, see pg. 13
No Power at Rotating Floor Brush
Possible Causes
1Cylinder is not securely seated
2Brush Switch turned to “Off”
3Vacuum is in Upright Position
Vacuum cleaner won’t pick up dirt
Possible Causes
1Incorrect Height Adjustment
2Hose not attached to suction opening
3Crack or hole in Hose
4Drive Belt broken, worn or off motor pulley
5Rotating Floor Brush bristles worn
6Rotating Floor Brush jammed
7Clog in vacuum
8Dirt Container full
9Dirt Container or Upper Tank not installed properly
10Filters are dirty
Remedies
1Remove Cylinder and replace, making sure that it “clicks” into place
2Make sure Brush Switch is in “On” position
3Recline vacuum to operate brush
Remedies
1Adjust Powerfoot to correct height setting
2Grasp Hose Grip and firmly push onto the base
3Check Hose and replace if needed
4Reposition or replace Drive Belt, see pg.
5Replace Brush
6Remove Brush and clean debris from Brush Ends
7Follow instructions on pg. 13 for clearing clogs
8Empty Dirt Container
9Position correctly and lock in place
10Check and clean or replace Upper Tank,
Vacuum cleaner is difficult to push
Possible Causes | Remedies |
1Incorrect Height adjustment
Visible dirt escaping from cleaner
Possible Causes
1Dirt Container full
2Filter missing or installed incorrectly
3Dirt Container installed incorrectly
14
1Adjust Powerfoot to correct height setting
Remedies
1Empty Dirt Container
2Check Upper Tank,
3Pull out and
2/2/06 4:12:21 PM
