Bissell 3760 How To Use Your Lift-Off Spinpower, Power Switch/Brush Switch, Handle Positions

Attach Vacuum Hose and Tools Continued

Combination

3. Snap the Metal Telescoping Extension Wand, Crevice Tool Tool, and Combination Tool into storage clips as shown.

4.	On Board TurboBrush™ (Select Models Only)
	The TurboBrush Bracket slides onto the Hanger on
	the front of the Handle. Attach the Bracket by	Metal
	aligning the slots with the rectangular part on the	Telescoping
	Hanger as shown and pulling down until it is locked
		Extension
	into place.
		Wand
	Note: If you do not wish to store the TurboBrush
		Crevice Tool

on your Lift-Off vacuum, the Bracket may be hung on a wall for storage and the Hanger may be removed from the vacuum.

Place the TurboBrush in the Bracket by aligning the small holes near the brush roll with the tabs

at the bottom of the Bracket and snap the TurboBrushTurboBrush™ into place.

How To Use Your Lift-Off Spinpower

Power Switch/Brush Switch

The Power Switch is located just below the handle on the front of the Detachable Cylinder. Push the rocker switch “ON” (I) to vacuum, and “OFF” (O) when cleaning is complete.

The Brush Switch is located just below the handle on the front of the Detachable Cylinder next to the Power Switch. This switch turns the Rotating Brush on and off. The Brush Switch should be in the “ON” (I) position for normal carpet cleaning. You may want to turn the Brush Switch “OFF” (O) for bare floor cleaning or other delicate surfaces.

Note: Your BISSELL Lift-Off Spinpower vacuum is equipped with a special internal switch that turns the Rotating Brush off whenever the unit is in the Upright Position.

Handle Positions

1.Upright – For storage and above floor cleaning with tools.

2.Normal Cleaning – Press the Handle Release Pedal with your foot to recline.

CAUTION:

Before using your vacuum, make sure that the Dirt Container and Upper Tank are in locked position and that all Filters (Upper Tank, Pre-Motor and Post-Motor) are in place. Do not operate your vacuum without these Filters.

Brush

Power

Tip:

Your vacuum features a Quick-Release Cord Wrap. To remove the Power Cord quickly and easily, rotate the Upper Cord Wrap towards floor, and slip Power Cord from Upper and Lower Cord Wraps.

6

ug603-5570_3760E_1105.indd 6

2/2/06 4:12:12 PM