Bissell 68Z3 warranty Cleaning the Post-motor HEPA media filter, Maintenance and care, the room

Maintenance and care

Cleaning the Post-motor HEPA media filter*

The post-motor filter is a H13 HEPA
media filter*, which assists in the fil-
tration process to return clean air to		2.
the room.
1.	Turn the power OFF. Unplug the vacuum
	from the electrical outlet.
2.	The post-motor filter is located behind
	the door labeled “FILTER” on the rear of
	the vacuum. Open the door by pushing
	down on the tab of the door and pulling
	out to remove.
3.	Remove the post-motor HEPA media	3.
	filter* by grasping the handle on the	Post-Motor HEPA
	filter and pulling out to remove.	Media Filter*

4.Replace the post-motor HEPA media filter* with a new filter.

NOTE: The post-motor filter is a white, pleated HEPA media filter*. This filter is NOT washable and must be replaced when it becomes dirty.

5.Replace the filter door by inserting the two tabs at the bottom of the filter door. Then push down on the tab on the door and push it back into the vacuum. Release the tab on the door to lock into place.

*The Filter Media, not the vacuum as a whole, complies with the High Efficiency Particulate Air (HEPA) filter specification (EN 1822-1:2009).

11

w w w . b i s s e l l . c o m