Operation
Carpet cleaning
1.With your foot, press the red power switch [located in foot of unit] ON .
2.With foot, press the detent lever on left side of lower body.
3.Depress spray trigger to spray cleaning solution.
Do not overwet.
4.To suction up water, repeat motion over same area without pressing trigger.
5.Repeat steps 3 and 4 until no more dirt can be removed.
6.Continue to clean entire carpet, working in 3’ x 4’ sections.
7.Empty the collection tank when dirty water reaches the full line, or when the solution tank is empty.
8.If floor nozzle stops spraying, turn power switch OFF and check water and cleaning solution levels. Refill if needed.
To empty the collection tank
2a.
1.Turn power switch OFF and unplug power cord from outlet.
2.Remove and empty collection tank.
a.Release collection tank latches [1 each side] by pulling up from bottom of latch and then out.
b.Carefully remove collection tank from lower body by lifting handle.
c.Carry collection tank to a toilet or sink. To empty, pour out contents using opening at 2c. back of tank.
d.Rinse collection tank thoroughly.
e.Remove lint and hair from red gasket in base of unit. (Do not remove gasket)
3.Clean nozzle window by lifting latch and removing from machine. Rinse under running water. When
finished replace nozzle and secure with latch. | 3a. | |
NOTE: For best results, it is recommended | ||
| ||
that the nozzle is cleaned after each use. |
|
4.Replace collection tank on lower body and secure with latches.
4
Tip:
It is recommended that every time your solution tank needs refilling, that you empty the contents of the collection tank. If the collection tank gets too full, you may begin to see foam spitting out of the vent cover. If this happens empty the collection tank.
2b.
2e.
3b.
16 w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |
