Operation
Getting ready to wet clean
NOTE: Remove tool caddy if in place.
1.Attach the desired wet cleaning tool to end of wand or grip.
2.Open the Quick Release™ Hose Door and select “WET CLEAN” with the mode selector.
3.Place the clean solution tank on a flat surface.
4.Fill the solution tank by first unscrewing the measuring cap. Always use genuine BISSELL formulas to maximize cleaning and for the safety of your machine. Fill tank to fill line with hot tap water. Add two full measuring caps of formula. Screw measuring cap tightly back onto the solution tank.
5.Place the solution tank back in the machine.
6.Make sure the float is in place. To install, slide float into the channel located on "Fill Line" side of the collection tank. There is only one way to properly install the float.
7.Plug into a proper outlet and press the ON/ OFF, wet clean and heater (if desired) buttons down into the ON position.
Note: Allow one minute for the
1610 w w w . b i s s e l l . c o m
Tip:
Move furniture to another area if cleaning an entire room.
24a
4b4c
4d5
8 0 0 . 2 3 7 . 7 6 9 1
10/30/07 3:39:45 PM |
