Troubleshooting

Reduce Spray or No Spray

Possible Cause

1.Make sure power is on

2.Solution tank may be empty

3.Tank may not be seated properly

4.Hose solution line may be disconnected

5.Wet clean is not turned on

WARNING:

To reduce the risk of fire, electric shock or injury unplug from outlet before servicing.

Remedies

1.Press power button if needed

2.Fill tank according to directions

3.Turn ON/OFF, heater and wet clean button off. Remove and reseat tank

4.Check connection at front of machine

5.Depress wet clean button to turn on

Machine is not suctioning

Possible Cause

1.Collection tank may not be placed properly

2.Collection tank may not be assembled properly

3.Wand tool connections are not tight

4.Collection tank is full

5.Float has tripped

6.Pre-motor filter is dirty

Remedies

1.Open Quick Release™ Hose Door, lift out tank and re-seat. Re-latch Quick Release™ Hose Door

2.Check to make sure the top lid is properly seated

3.Check all connections (At grip, wand and tool) Push tight if necessary

4.Empty collection tank by following instruction on page 9

5.Check to see if tank needs to be emptied. Make sure float is down towards bottom of tank

6.Remove top lid. Remove and clean pre-motor filter by following instructions on page 15

Filter must be completely dry before using again

Built-in heater light does not illuminate

Possible Cause

Remedies

1.

The heater button has not been depressed

1.

Depress the heater button

2.

The ON/OFF button has not been depressed

2.

Depress the ON/OFF button

Other maintenance or service not included in the manual should be performed by an

authorized service representative.

Thank you for selecting a BISSELL product.

Please do not return this product to the store.

16 w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

ug120-4004_7700_807.indd 16

10/30/07 3:41:00 PM

Page 16
Image 16
Bissell 7700 warranty Troubleshooting, Reduce Spray or No Spray, Machine is not suctioning