Operation
Carpet Cleaning
1.Attach carpet deep cleaning tool to end of wand.
2.Place carpet deep cleaning tool directly on carpet. Pull the spray trigger to spray cleaning solution while pulling the wand towards you.
3.Keeping nozzle of the carpet deep cleaning tool firmly against the carpet surface, continue to make slow forward and backward wet passes until no more dirt can be removed.
Do not overwet.
4.Release spray trigger and make slow forward and backward passes over the same area to remove any residual dirty water.
5.Repeat wet cleaning passes until water being pulled up appears clean.
6.Continue passes without pressing the spray trigger until you can't see any more water being pulled up.
7.Continue to clean entire carpet working in 3' by 3' sections.
8.If machine loses suction, stop spraying and check the collection tank level. Empty if necessary.
9.If the machine stops spraying turn off
wet clean button immediately and check the solution tank level.
NOTE: Never run in wet clean mode when the clean water formula tank is dry or missing.
w w w . b i s s e l l . c o m
ATTENTION:
Some Berber carpets have a tendency to fuzz with wear. Repeated strokes in the same area with an ordinary vacuum or deep cleaner may aggravate this condition.
8 0 0 . 2 3 7 . 7 6 9 1 | 116 |
10/30/07 3:40:05 PM |
