Maintenance and care

Cleaning the inner & outer circular filters

Use only BISSELL Style 12 replacement filters in your BISSELL PowerForce Turbo Bagless.

1.Unplug cleaner from electrical outlet.

2.Remove the dirt container as described in the previous section. Grasp the filter cup located at the bottom of the dirt container and twist counterclockwise to unlock and remove.

3.Grasp the circular filters and pull straight up to remove.

4.Separate the outer foam and inner pleated circular filters. Wash each individually by hand in warm water. Mild detergent may be used if desired. Rinse well, then air dry thoroughly before putting them back together and replacing in filter cup.

5.The filter cup may be washed in warm water with a mild detergent. Make sure it is completely dry before reassembling with filters.

6.The upper tank and primary separator may be wiped clean with a damp cloth. Reach underneath the upper tank and turn the rim of the primary separator to unlock. Pull straight down to remove.

NOTICE:

This product is intended for household use only and not for commercial or industrial use. Vacuuming of dust from products like plaster, concrete or ashes will damage the motor and void the warranty.

Cleaning the pre-motor filter

1.Unplug the cleaner from electrical outlet.

2.The pre-motor filter protects the motor from debris. It is located underneath the dirt container and filter cup in the center of the round part of the Lock ‘n Seal lever.

3.Remove the small, round, pre-motor filter and any debris on top of it. Rinse well under warm water, then air dry thoroughly before replacing.

w w w . b i s s e l l . c o m

WARNING:

Do not operate cleaner with damp or wet filters or without all filters in place.

Pre-Motor

Filter

169

ug110-4049_82H5_1008.indd 9

10/14/08 2:40:31 PM

Page 9
Image 9
Bissell 82H5 warranty 169, Cleaning the pre-motor filter, Unplug cleaner from electrical outlet, Pre-Motor Filter