RZ 2610001563 07-09:RZ 2610001563 07-09 7/24/09 10:13 AM Page 20
MAKING A CUT
1. Your jigsaw handle attachment is equipped with a trigger switch. Slide the lock- out lever (figure 7) to either side with your thumb, then squeeze the trigger.
FIG. 7
LOCK OUT
LEVER
TRIGGER
4.Release the trigger to
FIG. 8
FIG. 9
2.While holding the tool firmly, insert the bit into the material at a 45° angle (figure 8).
3.Slowly bring it to a 90° angle to begin the cut. The base plate should be flush to the material surface (figure 9).
Maintenance
Service
Preventive maintenance
!WARNING performed by unauthorized personnel may result in misplacing of internal wires and components which could cause serious hazard. We recommend that all tool service be performed by a Bosch or Rotozip Factory Service Center or Authorized Bosch Service Station. Call 1-
TOOL LUBRICATION
Your Rotozip tool has been properly lubricated and is ready to use. The lubrication applied at the factory lasts for the life of the tool.
CARBON BRUSHES
The brushes and commutator in your tool have been engineered for many hours of dependable service. To maintain peak efficiency of the motor, we recommend every two to six months the brushes be examined. Only genuine Rotozip replacement brushes specially designed for your tool should be used.
BEARINGS
Your Rotozip tool and attachments contain sealed bearings designed to last the life of the
tool. Bearings which become noisy (due to heavy load or very abrasive material cutting) should be inspected at once to avoid overheating or motor failure. Contact your local Bosch or Rotozip Factory Service Center if your bearings become noisy.
Cleaning
To avoid accidents always disconnect the tool from the power supply before cleaning or
performing any maintenance. The tool may be cleaned most effectively with compressed dry air. Always wear safety goggles when cleaning tools with compressed air.
Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not attempt to clean by inserting pointed objects through openings.
Certain cleaning agents ! CAUTION and solvents damage
plastic parts. Some of these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that contain ammonia.
