RotoZip RZ2000 Electronic Variable Speed Control, Depth Guide Adjustment, Thumb Screw Worklight

RZ 2610001563 07-09:RZ 2610001563 07-09 7/24/09 10:13 AM Page 11

ELECTRONIC VARIABLE SPEED	FIG. 7
CONTROL
The electronic speed control feature allows
motor speed to be matched to cutter size and
material hardness for improved finish,
extended bit life, and higher performance.
Speed changes are achieved by rotating
Control Dial UP to increase speed, DOWN to
decrease as indicated on housing (Fig. 7).
Speed may be changed while tool is on. The
reference numbers on the dial facilitate re-
setting control to desired speed.

SPEED

CONTROL DIAL

DEPTH GUIDE ADJUSTMENT

Use the depth guide to adjust the depth of cut. Loosen the thumb screw by turning it counter-clockwise until the depth guide can slide freely to the desired depth of cut (about 1/8” greater than material thickness) and retighten the thumb screw (clockwise) (Fig. 8). For bits with a guide point, make sure that the entire guide point tip will extend 1/8” beyond the material thickness (Fig. 2). For standard point bits, make sure that the fluted end of the bit extends 1/8” beyond the material thickness.

FIG. 8

1/8"

THUMB

SCREW

WORKLIGHT

Your tool is also equipped with a light that turns on automatically when the switch is

activated, for better visibility when cutting (Fig. 1).

-11-