RZ 2610001563 07-09:RZ 2610001563 07-09 7/24/09 10:13 AM Page 15
Assembly
Disconnect the plug from ! WARNING the power source before
making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.
Guard plug should always ! WARNING be attached when vacuum
hose is not connected. Wheel bursting may eject wheel fragments towards user if guard plug is not attached.
REMOVING AND INSTALLING
ABRASIVE CUT OFF ATTACHMENT
1.Depress and hold the
2.Remove the collet nut by rotating it counter- clockwise. Remove the collet from the tool shaft.
3.Position the attachment onto the threaded Rotozip Connect™ interface. Note: It may be necessary to rotate attachment slightly to engage square end of the right angle drive into tool shaft (figure 2).
4.Position attachment in desired orientation and rotate the locking collar until the attachment is secure. The locking collar has been tightened sufficiently when the Zipmate body can no longer move relative to the Spiral Saw® (figure 3).
ATTACHMENT
FIG. 2
ROTOZIP
CONNECT™ INTERFACE
ATTACHMENT
FIG. 3
